The largest independent, non-commercial, consumer-oriented resource on the Internet for owners, collectors and enthusiasts of fine wristwatches. Online since 1998.
Informational Websites ChronoMaddox -- the legacy of Chuck Maddox OnTheDash -- vintage Heuer website Zowie -- Omega information
Discussion Forums ChronoMaddox Forum Heuer Forum Omega Forum
Counterfeit Watchers ChronoTools Forum ChronoTrader Forum
Vintage Heuer Discussion Forum
The place for discussing 1930-1985 Heuer wristwatches, chronographs and dash-mounted timepieces. Online since May 2003.
OnTheDash Home What's New! Price Guide Chronographs Dash Mounted Collection
Re: Autavia 11630 Pusher Spline Size

Hi Victor

This might help you even though it is not an answer to your question.

From Cousins UK I have had these two, but had to return both because one was too big and one too small.
- Chronograph Pusher Tube Tool Spline Ø3.33mm
- Chronograph Pusher Tube Tool Spline Ø3.65mm

Therefor the other Cousins sizes Ø3.05 and Ø4.10 can't be the right.

Peter. Denmark

: Hi All,

: In the midst of an Autavia restoration and find myself in need of a
: new tool! I cannot measure accurately enough the spline diameter
: on my watch as I get such little room with the calipers - is it
: a 3.50 or 3.60mm tool that I need to remove them from the case?

: Hopefully someone in the know can enlighten me!

: Thanks, Vic

Current Position
Chronocentric and zOwie site design and contents (c) Copyright 1998-2005, Derek Ziglar; Copyright 2005-2008, Jeffrey M. Stein. All rights reserved. Use of this web site constitutes acceptance of the terms of use. CONTACT | TERMS OF USE | TRANSLATE