The largest independent, non-commercial, consumer-oriented resource on the Internet for owners, collectors and enthusiasts of fine wristwatches. Online since 1998.
Informational Websites ChronoMaddox -- the legacy of Chuck Maddox OnTheDash -- vintage Heuer website Zowie -- Omega information
Discussion Forums ChronoMaddox Forum Heuer Forum Omega Forum
Counterfeit Watchers ChronoTools Forum ChronoTrader Forum
Vintage Heuer Discussion Forum
The place for discussing 1930-1985 Heuer wristwatches, chronographs and dash-mounted timepieces. Online since May 2003.
OnTheDash Home What's New! Price Guide Chronographs Dash Mounted Collection
Re: Autavia 11630 Pusher Spline Size

: Hi Victor

: This might help you even though it is not an answer to your
: question.

: From Cousins UK I have had these two, but had to return both
: because one was too big and one too small.
: - Chronograph Pusher Tube Tool Spline Ø3.33mm
: - Chronograph Pusher Tube Tool Spline Ø3.65mm

: Therefor the other Cousins sizes Ø3.05 and Ø4.10 can't be the
: right.


: Peter. Denmark

Thanks very much Peter, from a fellow half-Dane!

I have ended up ordering a tool with a selection of spline fittings, so I hope one is the right size.

Thanks & stay safe, Vic

Current Position
Chronocentric and zOwie site design and contents (c) Copyright 1998-2005, Derek Ziglar; Copyright 2005-2008, Jeffrey M. Stein. All rights reserved. Use of this web site constitutes acceptance of the terms of use. CONTACT | TERMS OF USE | TRANSLATE